10
MAINTENANCE & DISMOUNTING
MAINTENANCE
a) Check mounting bolts at frequent intervals for
proper tightness to be sure equipment is in safe
working condition.
b) Apply oil at all pivot points.
DRIVE MECHANISM DISMOUNTING
SEE ATTACHMENT OWNER'S MANUAL
(SNOWBLOWER, BROOM AND BLADE) FOR
DISMOUNTING INSTRUCTIONS.
a) Dismount the attachment.
b) Remove the rear counterweight when you remove
the front attachment.
c) Tractor with manual clutch:
Remove the tractor belt guide and disconnect the
P.T.O.. clutch cable.
c)
Dismount the drive mechanism by removing the
front pin. Carefully lower to the ground. Remove the
belt from engine pulley.
d) You may leave the subframe on tractor all year long
or remove it if preferred.
e) Reinstall mower if needed.
Drive Mechanism Belt:
Before proceeding with this step, notice carefully how
the belt guide is installed to avoid damage to the belt.
When re-installing, remove the bolt which retains the
tension pulley and the belt guide. Replace the belt
and re-install the tension pulley and belt guide. Before
tightening make sure the belt guide does not touch
the belt at any time. Re-install the drive mechanism.
END OF SEASON STORAGE
a) Clean and paint all parts from which paint has worn.
b) Apply oil at all pivot points.
c) Inspect and replace all defective parts before using
again.
VERIFY TIRE PRESSURE:
VERIFY TIRE PRESSURE:
Tire pressure must be even on both sides of tractor
according to the vehicle’s owner’s manual.
BELT REPLACEMENT
Belt for the accessories:
SEE ATTACHMENT OWNER'S MANUAL
(SNOWBLOWER AND BROOM ) FOR REPLACING
INSTRUCTIONS.
