Beper 90.520, Use Instructions

Page: 10 / 36

10
Drip Coffee maker Use instructions
BEFORE FIRST USE
Check that all accessories are complete and the unit is not damaged. Add water into water tank (4) to the max
level and brew water for several times without coffee powder, then discard the water. Clean all detachable parts
thoroughly with warm water.
USING YOUR COFFEE MAKER
1. Open the top lid and fill the water tank (4) with drinking water. The water level should not exceed the maximum
level marked in water gauge (5).
2. Place the funnel into the funnel support and make sure the funnel is assembled correctly. Then put the filter
correctly.
3. Add coffee powder into filter (1). Usually a cup of coffee need a level spoon of coffee powder, but you may
adjust according to personal taste. Then close the top lid.
4.Place the carafe on the keeping warm plate (7).
5. Plug the power cord into the outlet. The LCD will display will flash.
6. Press on/auto/off button once, the indicator in it will be illuminated red. The appliance will begin working.
7. The brewing process can be interrupted by pressing the on/auto/off button twice at any time during operation,
and the indicator in it will be illuminated blue, after about 15s, it will be extinguished. The appliance will continue
brewing once on/auto/off is pressed again.
8. Remove out carafe to serve when finish brewing (about one minute later after the coffee stops dripping out.)
9. When the process is finished, if you do not want to serve immediately, keep the coffee maker is energized, the
coffee can be kept warm in the keeping warm plate (7). The appliance will be cut off power automatically after 40
minute if it has not been manually disconnected at the completion of brewing.
10. Always turn the coffee maker off and disconnect the power supply when not use.
AUTOMATIC START FUNCTION
If you do not want the coffee maker to start operation immediately, first follow steps 1 to 5 of above section, then
you can set the automatic start function as follows:
1. Press PROG button one time, the word CLOCK is showed at the up-right corner on display.
2. Press the HOUR and MIN button continuously to set the present time (real clock)
3. Press PROG button again and the word TIMER shows on up-left corner of display.
4. Set the delayed starting time by pressing HOUR oand MIN button repetitively.
5. After setting the presetting time, press the PROG button once, the letter TIMER on the LCD will disappear. The
LCD will display the current clock. After 15s, the blue indicator in PROG button will be extinguished.
6. Press the on/auto/off button twice, the indicator in it will illuminate blue and flash. The LCD will display the
current clock. You may see the automatic start time by pressing PROG twice.
Note: You may cancel the automatic start function by pressing on/auto/off button once to stop machine, if you
want to brew coffee again immediately, you shall press on/auto/off button once again to start brewing immedia-
tely. If you want to change the automatic start time, only following the above 1-4 steps again.
When the time is due the blue indicator in on/auto/off will stop flashing and illuminate red, then the unit starts
brewing. The appliance will be cut off power automatically after 40 minute if it has not been manually discon-
nected at the completion of brewing.
CLEANING AND CARE OF THE COFFEE MAKER
Before cleaning the coffee maker, unplug the appliance from the socket.
Wait as necessary that all the hot parts are cool.
Clean the main body with a soft wet cloth. Do not immerse the coffee maker into water.
Do not spray detergent directly onto the coffee maker, if necessary, use the detergent on a cloth.
The cup, the permanent filter and filter must be cleaned thoroughly with warm water and detergent.
At least 4-5 times a year clean the water pipe to prevent it from limestone deposit.
It is recommended to use white wine vinegar.
Put one cup of vinegar into the water tank (3) and turn on the coffee maker.
CONTROL PANEL