29
8.3 METHOD TO BE FOLLOWED IN CASES OF ACCIDENT OR BREAKDOWN
Use the hand crank to lower the load by hand the in case of emergency.
WARNING: RISK OF PERSONAL INJURY!
For product size 100, 125, 200 the jack shall be lowered by additional persons.
8.4 STORING AND PROTECTING
In the event that equipment is to be held in storage, for a period exceeding 6 months, prior to installation
or commissioning, AB Benzlers must be consulted regarding special preservation requirements. Unless
otherwise agreed, equipment must be stored in a dry environment protected from extremes of temperature,
dust, dirt and humidity to prevent deterioration. The rotating components (gears and shafts) must be turned a
few revolutions once a month (to prevent bearings brinelling). If the the storage period exceeds five years the
grease must be changed.
8.5 TAKING PRODUCT OUT OF OPERATION
• The jack shall be unloaded and the lifting screw shall be in zero postion during decommissioning.
• To lift the jack, see ”Lifting” on page 23.
8.5.1 Advice on disposal / disposal of waste
Metals, PVC and rubber etc. should be seperated for recycling and lubricants for disposal at a local recycling
center. For further information
and references contact AB Benzlers.
9
MAINTENANCE AND CLEANING
Prior to maintenance & cleaning, make sure that you have read and understood the section ”Safety
information” on page 17 and forward.
DANGER: CRUSHING RISK!
Never start the machine when people are inside the risk area.
