benza CR 350, Use And Maintenance Manual, Page: 62 / 100

14
9. ADJUSTMENT
Do not use blade discs with a diameter in excess of 350 mm and with an inner diameter other than 25.4 mm.
Do not use blade discs other than those specified for this machine:
- Diamond blade disc for floor cutting.
In the event of detecting any fault in an element of the machine, take it out of service and contact your dealer
or the manufacturer.
Cutting depth:
Handle height:
- Turning the wheel right or left, we will raise or
lower the disc to adjust cutting depth.
- Start cutting slowly and uniformly.
- The handle of the machine can be adjusted to
several heights.
- Loosen the flange screws (part 1)
- Place the handle at the desired height.
- And tighten the flange screws back again