Beny Sports Herculean V-FIT STG/09-2, Manual

Page: 18 / 28

3.
Please assemble the Rear
Upright Frame (12) with the
large welded support washers
(near the top) facing outwards.
Note
1. Attach the Support Frame (8) to the Base Frame (2), using two M10 x 70mm
Hex Bolts (63), four M10 Washers (77) and two M10 Nylon Nuts (83).
2. Remove the two M10x20mm Hex Bolts (69) and two M10 Washers (77) from
the top of both Weight Guide Tubes (15).
3. Attach the Upper Cross Beam (7) to the Weight Guide Tubes (15), using the
two M10 x 20mm Hex Bolts (69) and two M10 Washers (77) previously removed.
4. Attach the Upper Cross Beam (7) to the Support Frame (8), using two M10 x 70mm
Hex Bolts (63), four M10 Washers (77) and two M10 Nylon Nuts (83).
5. Attach the Connect Frame (13) to the Upper Cross Beam (7), using three
M10 x 20mm Hex Bolts (69) and three M10 Washers (77).
6. Attach the Rear Upright Frame (12) to the Back Base Frame (3) and the Connect
Frame (13), using three M10 x 70mm Hex Bolts (63), six M10 Washers (77)
and three M10 Nylon Nuts (83).
NOTE: Do NOT fully tighten any of the Nuts and Bolts fitted in this stage until all
Frames are assembled.
Page 1