8
You can save up to 29 programmes in your TC505.
Once a firing curve has been saved as a programme it
can be called up easily to be modified, saved again or
simply used by starting the firing.
To save a firing curve that has been entered before as
e.g. programme number 25 proceed with the following
steps: Press key (8). The display (14) asks for the
programme number as shown on the left („programme
save“). Now enter the programme number „25“.
Please note that a programme number must always be
entered as a two digit number (e.g. „0“ and „9“ for
programme no 9).
After successfully saving the current firing curve the
display (14) reads the final temperature of the
programme (or the current firing). If the display shows
„PS.- -“ you have tried to enter an invalid programme
number which has been rejected by the controller.
The first 6 programmes are factory set and cannot be
changed. This ensures that you always have a set of 6
standard firing curves available. The values of these
programme number 1 to 6 were listet on page no. 5.
The programmes number 7 to 29 can be set according
to your requirements as described previously. You can
change and update them as often as you wish.
Presuming you frequently need a firing curve which is
the same as preset programme no. 5 but with a final
temperature of 1195°C and 20 minutes dwell. This
programme is to be saved as no. 15.
Call up programme no. 5 and change the final tempe-
rature (1195°C) and dwell (20 min). Now save the
firing curve as programme no. 15.
Note
The progamme number
must always
be entered as a 2
digit number. Example: Enter „05“ for programme no. 5
t2
t1
t0
rmp3
rmp1
rmp2
tmp2
tmp1
°
C/h
h.min
°
C
°
F/h
°
F
Saving Programmes
Working with
Programmes
memo
2
event 2
5
prog
0
hold
5
tmp2
1
event 1
1
event 1
9
5
t2
2
event 2
0
hold
memo
1
event 1
5
