22
Press key
select
(21) and hold it pressed for about 3
seconds. The TC505 enters configuration showing the
first parameter of the list explained before. Display
(12) shows the parameter number while display (14)
shows the current value.
Use keys (5) and (6) to step through the parameterlist
explained before. To change a parameter use keypad
(18). Note a number of parameters can also be altered
by using the keys
t2
(17) and
rmp3
(16). Key (10) is
used as decimal point (e.g. to enter the kilns power
rating).
To leave the configuration press and hold the key (21)
for 3 seconds. If you have altered any parameters and
you would like to keep them permanently, hold key
select
(21) until the display as shown on the left hand
side appears („
Save okay
“). This special requirement
avoids unintentional parameter change.
The parameter list described earlier is kept simple and
compact to make changes understandable. Parameter
changes allow the adaption of the TC505 to almost all
applications. However, many functions of the TC505
are hidden using this parameter list.
The large parameter list includes more than 2000
parameters and allows totally free configuration of the
entire controller design. Zonewise control channel
configuration, servo motor control, analog outputs
and many features more can be configured.
The large parameter list is selected by setting a jumper
inside the TC505. Configuring the large parameter list
on TC505 is either done over the keyboard or by
using our Microsoft Windows based software bentrup
WinConfig (only on TC505 fitted with data link - see
appendix D).
For further details please check the „Technical Manual
TC500 Series Controllers“. This manual - as well as
WinConfig - can be downloaded as PDF file on our
homepage
http://www.bentrup.de
free of charge.
Z3
Z 1
Z2
t2
t1
t0
o
rmp3
rmp1
rmp2
tmp2
tmp1
°
C/h
h.min
°
C
°
F/h
°
F
k
Calling up the
Configuration
Large
Parameter List
