Bentone BFG 1 H1, Installation And Maintenance Instruction

Page: 28 / 60

28 Bentone BFG1
!
When servicing/replacing components which affect the combustion, gas side
leakage analysis and check should be performed on the system.
!
Warning
5.1.6.1 Complete electrical package replacement
1. Switch off the main current, disconnect the Eurostecker from the
burner and turn off the gas.
2. Loosen the screw assembling the front piece of the burner and the fan
housing, but not more than that the fan housing can be removed from
the front piece. Disconnect the cables to the multiblock.
3. Remove the fan housing from the front piece and pull it backwards
until the cables to the ignition electrode and ionisation electrode can be
loosened.
4. Disconnect the electric contact to the motor and the multiblock.
5. Open the air pressure switch and disconnect the cables. Note how
the air pressure switch is connected.
6. Loosen the screw holding the electrical bracket.
7. Disconnect the ignition electrode and ionisation electrode cables
from the electrical package.
8. Attach the new electrical package.
9. Connect the ignition electrode and ionisation electrode in the new
electrical package.
10. Install the screws in the electrical bracket.
11. Connect the cables to the air pressure switch and install the cover.
Ensure correct connection.
12. Connect the motor cable and multiblock.
13. Assemble the fan housing and front piece.
14. Install the Eurostecker; switch on the main current and open the gas flow.
15. Start the burner and check the combustion.
5.1.6 Electrical package
Check that the screw holding the electrical bracket is tightened so that good
earth connection between the package and the burner body is obtained.
Use only electric components recommended by Enertech.