7
Introduction
Enrolling an LCD Keypad at Address 08
To enrol an LCD Keypad at Address
08
from a LED Keypad, enter:
<Installer Code>
+
O
O
O
O
O
A short beep will indicate that the LCD Keypad has been enrolled.
NOTE - You must enrol the LCD Keypad at Address 8 (using DIP switches
[51]), before completing the connection (refer to Table 2.1 or 2.2 in the IN-
STALLATION MANUAL).
The following procedure will allow you to change the Kyo Control panel
parameters when:
The Programming Software is not available.
A system, previously programmed via an LCD Keypad, must be repro-
grammed via an LED Keypad.
The system is equipped with LED Keypads only.
Before ending the Programming session, you must DISABLE the Keypad at
Address 8 or re-enable the LED Keypad (refer to the “Keypads” paragraph in
this section).
Adjusting Contrast, Brightness and Volume
NOTE - For MIA, ALISON/S and ALISON/DVP only.
You can change the Display Contrast and Brightness, and the Buzzer Volume.
Changes can be made during
Standby status
only.
z
Brightness
Press and hold
A
A
A
A
A
(or
A
) to turn the Brightness up
Press and hold
B
B
B
B
B
(or
B
) to turn the Brightness down
z
Contrast
Press and hold
C
C
C
C
C
(or
C
) to turn the Contrast up
Press and hold
D
D
D
D
D
(or
D
) to turn the Contrast down
z
Volume
You can select 3 volume levels:
High
,
Medium
and
Mute
.
Press
eeeee
(or
e
) until you obtain the required Volume level.
Long high Beep
= High Volume
Long low Beep
= Average Volume
Short low Beep
= Mute
