29
Programming from the LED Keypad
Programming from the LED Keypad
Only the following models from the Kyo range can be programmed via LED
Keypad:
KYO 4M
KYO 4P
KYO 8M
KYO 8P
All Partitions must be Disarmed before starting the programming session.
1
.
From Standby status
, enter the Installer code (
0025 at Default
), then
press
E
E
E
E
E
.
If you enter a wrong code, the Control panel will emit an audible error signal.
When you access the Programming session, the Control panel will:
a
) activate the
P
indicator (slow blink) on LED Keypads;
b
) turn off all the indicators (
I
,
a
and
G
);
c
) clear the alarm memory;
d
) force all the outputs (Alarm and Open Collector) to standby status;
e
) stop the event evaluation;
f
)
if necessary
— interrupt ongoing calls, and put the Call queue on hold;
g)
lock all other Keypads, except for the one in use.
Exiting Programming
Press
e
e
e
e
e
to step back (the Control panel will take one step back each
time
e
e
e
e
e
is pressed).
When you exit the Programming session, the Control panel will:
a
) restore all other Keypads to Standby status;
b
) restore to Standby status or, if necessary, restart the call queue from the
interrupted call.
NOTE: Interrupted Teleservice calls will not be restarted.
c
) turn off the
P
light on the LED Keypads.
Accessing Programming
Accessing the
Programming session
