10
Multifunction Control Panel
Programming
e
and
E
NOTE: The examples in this section refer to the Kyo32 display (8 Partition
Control panel). Therefore, if you are using another type of Control panel, the
display messages/prompts may be slightly different.
Use the
e
e
e
e
e
key to step back at any point on the Installer Menu.
Use the
E
E
E
E
E
key to confirm entered data.
Actions
This option provides a further 4 sub-options:
a
)
Test Siren
— this option will allow you to Test the Alarm Output relay.
b
)
Zones Status
— this option will allow you to
Bypass/Unbypass zones
.
c
)
View Logger
— this option will allow you to view the events in the Logger.
d
)
Clear Call Queue
— this option will allow you to
interrupt ongoing calls
and stop the call queue.
You can find a full description of this options under ‘
Operating from a Key-
pad
’ in the ‘USER MANUAL’.
b
) clear the alarm memory;
c
) force all the outputs (Alarm and Open Collector)
to standby status;
d
) stop the event evaluation;
e
)
if necessary
— interrupt the ongoing call, and put the Call queue on hold;
f
) activate the
P
light (slow blink) on LED Keypads.
If you enter a Wrong Code the display will show an
error message, and go back to Standby status.
Exiting Programming
To exit Programming:
1
. Press
e
e
e
e
e
(as many times as necessary) to step back;
2
. Press
E
E
E
E
E
when the ‘Sure?’ prompt is shown.
If, at this point, you decide not to exit the menu, press
e
e
e
e
e
to continue.
When you exit the PROGRAMMING Menu the Control panel will:
a
) restore all other Keypads to Standby status;
b
) restore to Standby status or, if necessary, restart the call queue from the
interrupted call.
NOTE: Interrupted Teleservice calls will not be restarted.
c
) turn off the
P
light on the LED Keypads.
PROGRAMMING
Sure ?
WRONG CODE
Wrong Code
