32
Multifunction Control Panel
Setting up the Zones
1
. To set up the Type and Balance, enter a Parameter Number from
163 – 191
(refer to Tab. 7a for details), then press
E
.
NOTE:
At this point, keys
1
to
5
will allow you to program the Zone Type and
Balance (refer to “Meaning of LED/Key status” in Tab. 7a).
2
. Using keys
1
to
3
, select the Zone Type.
3
. Using keys
4
and/or
5
, select the Balance Type.
4
. Press
E
to confirm, or
e
to abort the setting.
1
. To assign the Zone Attributes, enter a Parameter Number from
164 – 192
(refer to Tab. 7a for details), then press
E
.
NOTE:
At this point, keys
1
to
8
correspond to Zones 1 to 8.
2
. Using the respective key, assign the Zone Attribute (refer to Tab. 7a for
details).
IMPORTANT
- Ensure that you DO NOT press keys
7
and
8
contempo-
rarily.
3
. Press
E
to confirm, or
e
to abort the setting.
Setting up the
Type and Balance
Zone Attributes
NOTE:
The ON, OFF, Slow or Fast Blinking status of each key determines
the status the respective Partition will adopt during
A Mode
(refer to “Mean-
ing of LED/Key status” in Tab. 6).
3
. Press
E
to confirm, or
e
to abort the setting.
NOTE:
The Reader will not accept “Z” Mode (Stay with 0 Delay).
1
. To set up the
B Mode
Arming configuration, enter a Parameter Number
from
24 – 159
(refer to Tab. 6 for details), then press
E
.
2
. Using keys
1
to
4
(respectively Partitions 1 to 4), set up the
B Mode
Arming configuration.
NOTE:
The ON, OFF, Slow or Fast Blinking status of each key determines
the status the respective Partition will adopt during
B Mode
(refer to “Mean-
ing of LED/Key status” in Tab. 6).
3
. Press
E
to confirm, or
e
to abort the setting.
NOTE:
The Reader will not accept “Z” Mode (Stay with 0 Delay).
B Mode Arming
