Silence
The
SILENCE
button can be used to force the Silenceable Output Points
into the Standby status:
Ø
In NIGHT Mode - Silence status will be held for the programmed Silence Time;
Ø
In DAY Mode - Silence status will be held until the SILENCE button is pres-
sed again.
+
In both functioning modes - Silence status will be overridden automatically
when a new alarm condition occurs.
Reset
RESET is one of the main commands on the control panel.
RESET
stops
ALARM, Prealarm, Warning and FAULT conditions. Access
to this command is limited to authorized key holders only (access level 2:
code or mechanical key).
During RESET the fire control panel will display the following messages.
If an ALARM, Prealarm, Warning or FAULT signal is still present after RE-
SET it will be reprocessed.
Command buttons (including ESC) cannot be used when RESET is running.
The Repeaters can be RESET by the Installer or User PIN.
Test
The TEST button activates all the control panel LEDs, buzzers and con-
nected Repeater buzzers.
The FC200/COM Telecom Module ---- that when properly programmed will
call the programmed telephone numbers.
Day/Night Mode
The control panel can operate in two modes: DAY Mode and NIGHT Mode.
Ø
If SILENCE is activated during DAY Mode its effect will be unlimited (un-
less other events occur: new ALARMS, new FAULTS etc.).
RESET
RUNNING
Please Wait ...
16
Analogue Fire Control Panel
FireClass100
Summary of Contents for FireClass 100
Page 1: ......
Page 10: ...10 Analogue Fire Control Panel FireClass100...
