BENSON RS UHA, Assembly And Use Manual

Page: 16 / 40

HEATER INDICATOR LIGHTS
16
If a fault should occur with the heater the lights situated
at the right hand side of the heater will be illuminated
indicating the fault

Red Lockout indication (1) .
This will be illuminated if the heater has gone to
lockout due to the loss of flame sensing by the
flame probe situated in the burner assembly in order
to reset the heater the RESET Button
(2) should be
pressed (if fitted with remote controls the remote
reset button will reset this switch).

Yellow overheat indication (3) .
This will be illuminated if the heater has exceeded
the temperature set on the thermostat. The
thermostat will shut down the burner until the fan(s)
have cooled the chamber sufficiently and the burner
will re light.
If the yellow light is flashing this means that the
heater has gone to overheat and the LIMIT
thermostat has operated and shut down the burner
The heater will not re light until the LIMIT
(4) has
been reset this can be done by removing the plastic
cap covering the reset button and pushing the reset
replace cap
The cause of the overheat should be investigated
RECEIPT OF PRODUCT
Delivery & pre installation checks
The heater is supplied wrapped in heavy duty protective
polythene, mounted on a pallet.
On receipt of the heater, the following checks should
be carried out;
a) The model is as per order
b) That it is undamaged
c)
That it is suitable for the gas supply and pressure
d) That it is suitable for the electrical supply
If any of these points are not satisfied then contact
should be made with the Sales Office at
manufacturer. In the case of claims for damage,
this
must be reported in writing within 24 hours of
delivery, in order to comply with insurance
The instruction manual is an integral part of
the equipment and so, after the packaging
has been removed, make sure that it has
been collected and stored safety.
TRANSPORT
When moving the heater ensure that the
equipment used is capable of lifting and
supporting the weight of the heater
When lifting by fork truck ensure that the forks
support the weight