%**1
%**1
%**1
%**1
• Unscrew the cover plate of the expansion slot.
• Remove the plate and keep it for future use when you decide to remove
the module
• With the power off, slide the module into the slot
• Once it is slid in fully, snap in the module to make a proper connection and
fasten the screws
• Then connect the module to the fiber optical cable
• Turn on the power
Once the power is on, the yellow F1(or F2) card exist LED on the front
panel should be lit. Besides, once the fiber is appropriately connected
between fiber module and other network device, the link status shall be seen
by the lit state of the green LED: LINK/ACT for 100FX port.
Figure 2. Fiber module being installed