BenQ PM245P01 Series, Installation Manual

Page: 12 / 22

Last revised: May 17, 2013
10
KEY AND TONGUE: INTE KEY AND TONGUE: INTE KEY AND TONGUE: INTE KEY AND TONGUE: INTERLOCK RLOCK RLOCK RLOCK
Key and Tongue in a Zep Compatible design is also seen with the Interlock, a component that
couples and bonds two modules together. Here, the Key and Tongue are differently shaped,
but they still fit into the Zep Groove in the same manner as the Rockit.
Figure
Figure Figure
Figure 3
33
3----7
77
7: Interlock, Key and Tongue Side Views
: Interlock, Key and Tongue Side Views : Interlock, Key and Tongue Side Views
: Interlock, Key and Tongue Side Views
3.5 Zep Component Installation
INTERLOCK INSTALLA
INTERLOCK INSTALLA INTERLOCK INSTALLA
INTERLOCK INSTALLATION
TION TION
TION
The Interlock provides module-to-module frame bonding through the interface with the Zep
Groove. The Interlock is UL Listed to UL2703 and ETL Listed to UL2703.
Use the marks along the top edge of the Interlock piece to help align the parts and tighten
fasteners once interlock and module are aligned. The Interlock The Interlock The Interlock The Interlock part part part part is used to connect is used to connect is used to connect is used to connect
modules together. modules together. modules together. modules together.
Figure Figure Figure Figure 3 33 3----8 88 8: Interlock Alignment Marks : Interlock Alignment Marks : Interlock Alignment Marks : Interlock Alignment Marks
1. Insert and push the Key side of the Interlock firmly into the Zep Groove.
2. Place Zep Tool over the fastener with the 1 aligned with Interlock reference mark (Please
refer the figure on the next page).