Operation
24
Adjusting surface fit
Manually correct geographic distortion by Surface Fit calibration function.
1.
Press
MENU/EXIT
and then press / until the
DISPLAY
menu is highlighted.
2.
Press
to
highlight
Surface Fit
and press
MODE/ENTER
. The
Surface Fit
correction page displays.
3.
Press /
to
select
Horizontal
and press
MODE/ENTER
.
4.
Select the direction you want to adjust and press
MODE/ENTER
.
5.
Press / to adjust the left or/and right side convex or concave. Single side
adjustment is for distortion only.
6.
For both sides of the horizontal surface fit, use /
to adjust the center of the
curve because it is not always at the center.
To continue with the vertical surface fit adjustment,
1.
Press
MENU/EXIT
to go back to the surface fit page.
2.
Press /
to
select
Vertical
and press
MODE/ENTER
.
3.
Select the direction you want to adjust and press
MODE/ENTER
.
4.
Press /
to adjust the top or/and bottom side convex or concave. Single side
adjustment is for distortion only.
5.
For both sides of the vertical surface fit, use / to adjust the center of the curve
because it is not always at the center.
