Operation
22
Adjusting the projected image
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do this, press
AUTO
on
the projector or remote control. Within 3 seconds, the built-in Intelligent Auto
Adjustment function will re-adjust the values of Frequency and Clock to provide the best
picture quality.
The current source information will be displayed in the corner of the screen for 3 seconds.
This function is only available when PC signal (analog RGB) is selected.
Fine-tuning the image clarity
Sharpen the image by rotating the focus ring.
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either
the top or bottom. It occurs when the projector is not perpendicular to the screen.
To correct this, you will need to manually
correct it following these steps.
1.
Do one of the following steps to
display the keystone correction page.
•
Press
/
on the
projector or remote control.
•
Press
QUICK INSTALL
on
the remote control. Press
to highlight
2D Keystone
and
press
MODE/ENTER
.
•
Press
MENU/EXIT
and then
press / until the
DISPLAY
menu is
highlighted. Press to
highlight
2D Keystone
and
press
MODE/ENTER
.
2.
After the
2D Keystone
correction
page displays. Press
to correct
keystoning at the top of the image.
Press
to correct keystoning at the bottom of the image. Press on the
a
b
Press
.
Press
.
Press
.
Press
.
2D Keystone
MENU
Exit
