Operation
22
Operation
Starting up the projector
1.
Remove the lens cap.
2.
Plug the power cord into the projector and into a
wall socket. Turn on the wall socket switch
(where fitted). Check that the
POWER
indicator light
on the projector lights orange
after power has been applied.
Please use the original accessories (e.g. power cable) only with the
device to avoid possible dangers such as electric shock and fire.
3.
Press
POWER
on the projector
or remote
control
to start the projector and a start up tone sounds. The
POWER
indicator light
flashes green and stays green when the projector is on.
The start up procedure takes about 30 seconds. In the later stage of start up, a
startup logo is projected.
(If necessary) Rotate the focus ring to adjust the image clearness.
To turn off the ring tone, see
"Turning off the Power on/off ring tone" on page 39
for
details.
If the projector is still hot from previous activity, it will run the cooling fan for approximately 90 seconds
before energizing the lamp.
4.
To use the OSD menus, please set them to
your familiar language first.
5.
If you are prompted for a password, press the
arrow keys to enter a five digit password. See
"Utilizing the password function" on page 26
for details.
6.
Switch all of the connected equipment on.
7.
The projector will start to search for input
signals. The current input signal being scanned displays in the upper left corner of the
screen. If the projector doesn't detect a valid signal, the message '
No Signal
' will
continue displaying until an input signal is found.
You can also press
SOURCE
on the projector or remote control to select your
desired input signal. See
"Switching input signal" on page 29
for details.
If the frequency/resolution of the input signal exceeds the projector's operating range, you will see the
message '
Out of Range
'
displayed on a blank screen. Please change to an input signal which is compatible with
the projector's resolution or set the input signal to a lower setting. See
for details.
To maintain the lamp life, once you turn the projector on, wait at least 5 minutes before turning if off.
Please select language
Press Enter to confirm, Exit to leave
