Preparation
6
Wired connections
For projecting through a wired network, you need to connect the projector and your
device to the same local area network (LAN).
Setting up a wired network for the projector
If you are in a DHCP environment:
If your projector is in a DHCP environment, you do not have to manually set the IP
address. Follow the steps below to configure the wired network settings for the projector
in a DHCP environment:
1.
Connect the projector to a local area network via an RJ45 cable.
2.
Turn on the projector.
3.
Press
MENU
to open the
Advanced Menu
.
4.
Highlight
Network
and press
OK
.
5.
Highlight
Wired LAN
and press
OK
.
6.
Highlight
DHCP
and press
OK
.
7.
Select
On
and press
OK
.
8.
Highlight
Apply
and press
OK
.
9.
Re-enter the
Wired LAN
page and check if the
IP Address
,
Subnet Mask
,
Default Gateway
, and
DNS Server
have been automatically configured. Make
sure the
Status
is
Connect
.
If you are in a non-DHCP environment:
If your projector is in a non-DHCP environment, you need to manually set the IP Address,
Subnet Mask, Default Gateway, and DNS Server. Follow the steps below to configure the
wired network settings for the projector in a non-DHCP environment:
1.
Repeat step 1 to 5 described in
"If you are in a DHCP environment:" on page 6
2.
Highlight
DHCP
and press
OK
.
3.
Select
Off
then press
OK
.
4.
Contact your network administrator for information on the
IP Address
,
Subnet
Mask
,
Default Gateway
, and
DNS Server
settings.
5.
Enter the projector’s
IP Address
,
Subnet Mask
,
Default Gateway
, and
DNS
Server
and assign the values as needed.
6.
After finishing the settings, highlight
Apply
and press
OK
.
RJ45 cable
RJ45 cable
Laptop computer
Desktop computer
Projector
RJ45 cable
Wired LAN
Internet
If the
IP Address
still does not appear, contact your network administrator.