![background image](http://html1.mh-extra.com/html/benq/joybook-s33-series/joybook-s33-series_user-manual_2733884047.webp)
Using BIOS setup
43
• When disabled, diagnostic texts will be displayed
during system boot.
b. Legacy USB Support: This item allows the support of
legacy USB devices during system boot and under
DOS.
c. CPU Power Saving: This item determines if the CPU
supports enhanced C-state, which determines the
power management of CPU.
If you are not familiar with the items in Advanced menu, you are
advised to keep the default.
Security menu
The Security menu contains the security settings, which
safeguard your system against unauthorized use.
Do NOT set the BIOS security password without having
memorized it or written it down and stored it with your Joybook
warranty documentation. Should you happen to forget or mislay
the password once set, you will be greatly inconvenienced in
gaining subsequent access to your Joybook.
• Set Supervisor Password: This set of password controls access
to the whole BIOS setup menu. It must be set before User
Password can be set. When typing the password, first make
sure Num Lock is off, and then type your password in the
entry fields and press <Enter>. Confirm your password by
typing it again and pressing <Enter>.
• Set User Password: This set of password controls access to part
of the BIOS setup menu.
If Set Supervisor Password and Set User Password are both set,
you can enter either one of them during the password prompt.
To have full privileges in BIOS setup, enter Supervisor
Password.
Boot menu
The Boot menu contains the boot configuration settings of the
system. A list of devices will be displayed under Boot Sequence.
• Use <
!
> or <
"
> to select a device, and then press <F6> to
move it up or <F5> to move it down.
• To select a boot device manually, press the <F9> key when the
BenQ logo appears on the screen during system startup. The
Boot Menu will appear. Use the up and down arrow keys (
!
,
"
) to select a boot device, and then press <Enter> to confirm.
Exit menu
The Exit menu displays ways of exiting BIOS setup. After
finished with your settings, you must save and exit so that the
new settings can take effect.
• Exit Saving Changes: saves the changes you have made and
exits BIOS setup. After finishing with your settings, you must
save and exit so that the new settings can take effect.
• Exit Discarding Changes: exits BIOS setup without saving the
changes you have made.
• Load Setup Defaults: loads factory default values for all the
items.
• Discard Changes: cancels all changes since last save, without
exiting the BIOS setup utility.
• Save Changes: saves changes without exiting the BIOS setup
utility.
It is recommended that you go into BIOS to load setup defaults,
whenever you have installed new hardware components.