53
Maintenance
7. As shown in the illustration, lower the new lamp.
8. Tighten the screw that secures the lamp.
9. Ensure the handle is fully laid flat and locked in place.
• Loose screw may cause a bad connection, which could result in
malfunction.
• Do not over tighten the screw.
10. Replace the lamp cover on the projector.
11. Tighten the screw that secures the lamp cover.
• Loose screw may cause a bad connection, which could result in
malfunction.
• Do not over tighten the screw.
12. Connect the power and restart the projector.
13. After the startup logo displays, resetting the lamp timer via the OSD menu.
• Under
the
Advanced
OSD menu, go to
System Setup : Advanced
>
Reset Lamp Timer
, and
select
Reset
.
• Under
the
Basic
OSD menu, if there’s no signal connected to the projector, go to
Reset Lamp
Timer
and select
Reset
; if there are signals connected, go to
Settings
>
Reset Lamp Timer
,
and select
Reset
.
Do not reset if the lamp is not new or replaced as this could cause damage.
A "
Reset Successfully
" message displays to notify that the lamp time has been reset to "0".
1
2
