32
Additional information
Eng
lish
Installing the cable connector-panel cover
The cable connector-panel cover is used to cover those unsightly cables and connections in the rear of the
projector.
To install the cover:
1.
Repeat Step 1~Step 3 in the "To clean the filter:"
section.
See page 31
for details.
2.
Place a soft item on the desk for padding. Turn the
projector over so that you can locate the screws
that hold the back cover to the projector on the
both sides. Loosen the screws.
3.
Turn the projector back. Remove the back cover.
4.
Manage all the connected cables within the
indentation of the cable connector-panel cover
whilst installing it securely.
5.
Turn the projector over again. Tighten the screws
to hold the cable connector-panel cover and the
projector on the both sides.
6.
Re-install the filter cover securely.
7.
The installation is finished.
PE8720-en.book Page 32 Friday, May 13, 2005 5:19 PM
