![background image](http://html1.mh-extra.com/html/benq/commuter-cp220/commuter-cp220_user-manual_2734477030.webp)
Operation
24
Adjusting the projected image
Adjusting the projection angle
The projector is equipped with 1 quick-release adjuster foot and 1 rear adjuster foot. These
adjusters change the image height and projection angle. To adjust the projector:
1.
Press the front adjuster button and
lift the front of the projector. Once
the image is positioned where you
want it, release the front adjuster
button to lock the foot in position.
Do not look into the lens while the lamp is
on. The strong light from the lamp may
cause damage to your eyes.
Be careful when you press the adjuster
button as it is close to the exhaust vent
where hot air comes from.
2.
Screw the rear adjuster foot to fine
tune the horizontal angle.
To retract the foot, hold up the projector while pressing the front adjuster button, then
slowly lower the projector. Screw the rear adjuster foot in a reverse direction.
If the screen and the projector are not perpendicular to each other, the projected image
becomes vertically trapezoidal. To correct this situation, adjust the value of Keystone in the
Picture menu, on the projector control panel, or on the remote control. See
for details.
Auto-adjusting the image
In some cases, you may need to optimize the picture
quality. To do this, press AUTO on the control panel
of the projector or on the remote control. Within 3
seconds, the built-in Intelligent Auto Adjustment
function will re-adjust the values of Frequency, Clock,
and Keystone to provide the best picture quality.
The current source information will be displayed at
the bottom right of the screen for 3 seconds.
The screen will be blank while AUTO is functioning.
Fine-tuning the image size and clarity
1.
Adjust the projected image to the size
that you need using the zoom ring.
2.
Then sharpen the image by rotating
the focus ring.