36 Menu
operation
Network Settings menu
SYSTEM SETUP: BASIC menu
LAN Settings
•
Wired LAN
: See
BenQ Network Projector Operation Guide
.
•
AMX Device Discovery
: When this function is
On
, the projector can be
detected by AMX controller.
•
Network Standby
: This menu provides basic and advanced settings for network
control when the projector is in standby mode.
•
Enable Network Standby Mode
: Selecting
On
will keep the projector at a
lower power consumption than it is on while the projector is available for
network control. If selecting
Off
, the projector disconnects from network.
•
Auto Disable Network Standby Mode
: If
Enable Network Standby
Mode
is set at
On
, you can decide a time period in this menu to disable the
network standby function when there is no network activity occurs. Selecting
20 min
/
1 hr
/
3 hr
/
6 hr
sets the projector to switch to non-network standby
status after that period of time. Selecting
Never
will always keep the
projector connected for network control.
Language
Sets the language for the On-Screen Display (OSD) menus.
Splash Screen
Allows you to select which logo screen will be displayed during projector start-up.
Auto Off
Allows the projector to turn off automatically if no input signal is detected after a
set period of time to prevent unnecessary waste of lamp life.
Direct Power
On
Allows the projector to turn on automatically once the power is fed through the
power cord.
Menu Settings
•
Menu Position
: Sets the On-Screen Display (OSD) menu position.
•
Menu Display Time
: Sets the length of time the OSD will remain active after
your last key press.
•
Reminder Message
: Sets the reminder messages on or off.
Source
Rename
Renames the current input source to your desired name.
On the
Source Rename
page, use / / / , and
OK
to set the desired
characters for the connected source item.
When done, press
BACK
to save the changes and exit.
Auto Source
Allows the projector to automatically search for a signal.
