27
4.5. Set parameter in “Auto” window. If you have set “Restore address”, please tick “Restore
Data”.
4.6.Processing of upgrade. After cl
icking “Run”, the tool start to program. It is forbided to power
off monitor or switch off connection during programming.
4.7.Successful upgrade. When upgrade successful, there will be green Pass letter appearing.
5. Check the FW version after upgrade.
5.1. Verify the software version and turn off burn in mode.
(1)Connect source to monitor, and turn it on.
(2)DC off the monitor and press the “menu” key and DC on the monitor until the screen
lights, release the “menu”. Then press “menu” again, will pop up below image.
Summary of Contents for 9H.LDMLA.TB Series
