Switch mode, single-phase, sine-wave Inverter
Product line TEBEVERT
August 8, 2005 - DTL
19/21
No. 4219en R2
2) Switch on the DC supply by closing/inserting the disconnecting device
⇒
The LED is lit
(this indicates the DC input voltage is within the acceptable input range)
3) Switch on the inverter by pressing the ON/OFF switch.
⇒
Immediately after switching on the inverter, the LED is lit
(this indicates the inverter is switched on )
When the start-up phase of the inverter has been completed, the following
LED will also illuminate:
(indicates that output voltage of the
inverter is present )
Since the inverter is set to the operating mode "inverter priority”, switch-
over takes place from the commercial AC bypass voltage to the inverter
output.
3) Switch on the loads
⇒
The greater the connected load, the more LED’s will be lit to indicate the
approximate inverter output power.
(when the inverter is operating! )
5
Maintenance / repair
These inverter were designed for continuous operation and are practically
maintenance free. To ensure correct functioning, it is recommended that the flow
of cooling air be checked periodically and dust be removed from the cooling fan
area as necessary.
Attention!
Maintenance and repair of the inverter should only be carried out
by qualified personnel.
The chassis grounding point or the AC neutral conductor should
never be disconnected. It is essential to observe the safety notes!
