- 220 -
ENG
LUBRICATION SYSTEM
OIL PUMP REMOVAL
Removal:
NOTE
This procedure is only possible after removing the whole clutch.
1. Use a commonly found tool (pin and hook wrench), lock the
pump gear (19) and loosen the screw (21) and washer (20)
fastening Fig. A.
2. Remove the screws (17) locking the pump to the casing,
and the gasket (26) Fig.B.
If there is any damage/wear, replace the gasket.
Disassembly:
Once the pump body has been removed, disassemble by un-
screwing the assembly screws (10), separating the pump cover
(8) from the pump body (15). Take out the parts from the inside.
Check:
•
The pump body (15)
If there are any lines/damage/wear, replace.
•
Pump gear (19)
If there is any damage or wear to the gears, replace.
PRESSURE-RELIEF VALVE INSTALLATION
Check:
Before fi tting the valve, make sure that all of its component parts
are free from anomalies Fig. A.
If there is any damage or wear, replace.
Fitting:
Insert the pressure-relief valve (22) complete with O-ring inside
the bottom casing, by simply fi tting it in.
NOTE
Fig. B.Lubricate the pressure-relief valve carefully and plentifully
during insertion.
B
22
A
B
26
A
All manuals and user guides at all-guides.com
all-guides.com
Summary of Contents for BN600R 2014
