PART B: CONFIGURING SETTINGS FOR THE SERAPH
20 SERAPH SETTINGS: EMERGENCY
SELECTING ACTIVATION METHOD
You can determine the way the emergency cycle will be start-
ed:
•By pressing and holding down the BeneGuard button for
a few seconds once or
•By pressing the button briefly
twice
.
Click the arrow and highlight the desired option (1).
SELECTING CANCELLATION TIME
After pressing the BeneGuard button in order to start the
emergency cycle, calls and reports (short messages) can still
be cancelled. Cancellation time is a kind of delay: A report
will not be sent or a call will not be made if it is cancelled in
the pre-defined time.
You can select the time in seconds that the cancellation
needs to be done: Click the arrow and highlight the desired
option (2). Note that if the cancelling time is set to zero (0),
there is NO possibility to cancel the whole emergency cycle.
When cancelling the emergency call or report, the
Bene-
Guard button must be pressed and released during the time
of delay (e.g in 7 sec.). For more information, see
LING EMERGENCY CYCLE ON PAGE 40
.
STORING EMERGENCY NUMBERS FOR
REPORTS AND CALLS
The emergency reports are sent and emergency calls are
made to the emergency numbers stored in the
Reporting and
calling
list.
Key in the report numbers (3) and/or call numbers (4). The
names associating the numbers are displayed, if they are
stored in the phone book and read from there.
The numbers are in priority order, starting from the top of
the list. These numbers work as "a chain":
If the first number is unreachable (after two attempts), the
device calls or sends the report to the second number. If it
is not answered either, the device will go on to the third
number on the list and so on.
The device tries to reach contact with the other numbers
once
before moving on to the next number on the list. If
there is still no answer after going through the whole list,
the calling procedure will be started all over. The device
makes three rounds.
For more information on emergency cycle, see
