9
STEP 3
(Lifting Chain Installation)
COMPLETE THE FOLLOWING
PRIOR TO STANDING UP COLUMNS.
1.
With the Column laying on the Floor, slide the Lift Head
up towards the top of the Column. Remove the Cylinder
from Column. Keep track of the Cylinder Leveling Plug in
the base of the Cylinder and insure that it gets reinstalled.
(See Fig 3.1)
3. Remove the Hair Clip Pins and remove the Bottom
Sheave Cover. (See Fig 3.2)
4. Lay the Cylinder Chain in the Column resting one end
towards the bottom of the Column and curving the other
end into the bottom of the Lift Head. (See Fig 3.3)
Connecting the Lifting Chain to the Lift Head
5. Determine the proper orientation of the Chain
Connector. The Chain Connector must be installed with the
Hole for the Chain Master Link offset as shown.
(See Fig 3.4)
6. Connect the Chain Connector to the Chain using the
Chain Master Link. Bend the Cotter Pin. (See Fig 3.5)
7.
Install the Chain Connector into the Chain Connector
Bracket. Insure that the Chain Connector is installed with
the Hole for the Chain Master Link offset as shown
previously. (See Fig 3.6)
Fig 3.1
Fig 3.2
Fig 3.3
Fig 3.6
Fig 3.5
Fig 3.4
