_____________________________________________________________________________________
8300-088
AeroCruze 110 Installation Manual
Rev 1
Page 19
© Honeywell International Inc. Do not copy without express permission of Honeywell.
Press and hold the HOME key when powering up the GTN-650. Release the key when the display
activates. When the config mode screen shows, touch GTN Setup.
Touch RS232. On channel 1 output, select Aviation. Back out to the main config menu.
Touch ARINC-429. On channel 1 output, select GAMA 1, Speed LOW. Back out to the main config menu.
Touch Update Config Module.
Make sure the autopilot baud rate is set to 9600.
9.16
Garmin 695/696/795/796
Table 9-7 Garmin 696 Connections
Garmin 696 connections to autopilot
Garmin Power/Data
Cable
Signal Name
(Garmin)
Signal Name
(TruTrak)
P101 on
xCruze 110 AP
Blue Wire
GPS RS 232 OUT 1
Primary Serial Input
17
Select Tools -> Setup -> Interface
Select the drop down menu under Serial Data Format. Choose one of the formats that outputs NMEA
Out. There are three options:
-Aviation In/NMEA & VHF Out is 9600 baud
-GTX TIS-A In/NMEA & VHF Out is 9600 baud
-NMEA Out is 4800 baud
Be sure to match the autopilot baud rate setting to the correct one.
9.17
Garmin Aera 500-510-550-560
Table 9-8 Garmin 696 Connections
Garmin Aera connections to autopilot
Garmin Power/Data
Cable
Signal Name
(Garmin)
Signal Name
(TruTrak)
P101 on
xCruze 110 AP
Blue Wire
GPS RS 232 OUT 1
Primary Serial Input
17
Select Tools -> Setup -> Interface
