_____________________________________________________________________________________
8300-088
AeroCruze 110 Installation Manual
Rev 1
Page 16
© Honeywell International Inc. Do not copy without express permission of Honeywell.
9.9
AvMap EKP IV
The AvMap EKP IV requires a NMEA/DGPS adapter cable to provide data output. The AvMap EKP IV
must be configured to provide the correct output to the autopilot.
MENU’ 1 sec. + “COMMUNICATIONS” + ‘ENTER’ + “NMEA OUTPUT” + ‘ENTER’.
The Output NMEA0183 messages are RMC, RMB that need to be selected.
Note: The default baud rate is 4800. This is the baud rate that will be entered into the autopilot in the
setup mode. The yellow wire is the Data out TX wire.
Now the AvMap EKP IV is correctly set up to provide the RS-232 serial output required by your TruTrak
autopilot.
9.10
Garmin 155XL/250XL/300XL
Table 9-1 Garmin 155XL/250XL/300XL Connections
Garmin 155XL/250XL/300XL connections to autopilot
J1 on
Garmin unit
Signal Name
(Garmin)
Signal Name
(BendixKing)
P101 on
AP
19
GPS RS 232 OUT 2
Primary Serial Input
17
16
GPS ARINC 429 OUT A
ARINC-A
14
15
GPS ARINC 429 OUT B
ARINC-B
15
Press & hold
MSG
, rotate outer knob until I/O setup page is displayed. Press
CRSR
twice and rotate
inner knob to select “plotting” for output to autopilot. Rotate outer knob to advance cursor to the baud
rate field, select 9600. Press
CRSR
to finish.
To set the ARINC output. Remove the data cards turn the unit on. Press “enter” in response to “Select
operating mode Normal?” Press “enter” in response to “No Jeppesen database rte / prx limited to user
wpts ok?” After the satellite status page is displayed for 5 seconds the unit may be turned off.
With power OFF press and hold the
ENT
key and turn the power on (release the ENT key when the
display activates). You should be in the TEST MODE. Press the CRSR key then rotate the outer knob to
Select ARINC 429 CHANNEL. Press the CRSR key then rotate the inner knob to advance to OUTPUT and
select “w/o GAMA labels”
9.11
Garmin 430 and 530
Table 9-2 Garmin 430 and 530 Connections
Garmin 430 and 530 connections to autopilot
P4001 [P5001] on
Garmin 430 [530]
Signal Name
(Garmin)
Signal Name
(TruTrak)
P101 on
xCruze 110 AP
56
GPS RS 232 OUT 1
Primary Serial Input
17
46
GPS ARINC 429 OUT A
ARINC-A
14
47
GPS ARINC 429 OUT B
ARINC-B
15
