_____________________________________________________________________________________
8300-088
AeroCruze 110 Installation Manual
Rev 1
Page 14
© Honeywell International Inc. Do not copy without express permission of Honeywell.
Press the
MENU
key twice. Select ‘Set-Up Menu’. Press
ENTER
. Select ‘Input/Output’. Press
ENTER
. The input/output format is ‘No In/NMEA Out.’ Note that the baud rate is automatically
set at 4800 bps.
Note: This is the baud rate that will need to be entered in the setup mode of the autopilot.
Now the Garmin 195 is correctly set up to provide the RS-232 serial output required by your TruTrak
autopilot.
9.4
Garmin GPS 196/295
The Garmin 196 requires a Power/data cable (Garmin Part Number 010-10082-00) to provide data
output.
The Garmin 196 must be configured to provide the correct output to the autopilot.
Press the
MENU
key twice. Use the arrow keypad to select the ‘SETUP’ tab.
Within the Setup Menu select the ‘INTERFACE’ tab. Using the arrow keypad highlight the ‘Serial
Data Format’ field. Use the arrow keypad to select ‘NMEA In/NMEA Out’ and press
ENTER
.
Set the baud rate to 4800.
Note: This is the baud rate that will need to be entered in the setup mode of the autopilot.
Press
MENU
to enter the Advanced NMEA page. Select ‘Advanced NMEA Setup’ and press
ENTER
.
Using the arrow keypad and the
ENTER
key to turn OFF ‘GPS Status (GSA, GSV)’,
‘Waypoint/Route (WPL, RTE)’, and ‘GARMIN Proprietary’.
Now the Garmin 196 is correctly set up to provide the RS-232 serial output required by your TruTrak
autopilot.
9.5
Garmin GPS 296
The Garmin 296 must be configured to provide the correct output to the autopilot.
Press the
MENU
key twice. Use the rocker keypad to select the SETUP in the vertical tabs. Use
the rocker keypad to select the ‘COM 1’ tab.
Press the down portion of the rocker keypad to select the ‘FORMAT’ field.
Press
ENTER
and a popup window will show the available settings.
Use the rocker keypad to select ‘NMEA IN / NMEA OUT’ then press
ENTER
. Select 4800 for the
baud rate. Note: This is the baud rate that will need to be entered in the setup mode of the
autopilot.
Press
MENU
to enter the Advanced NMEA page. Select ‘Advanced NMEA Setup’ and press
ENTER
.
Using the arrow keypad and the
ENTER
key to select “FAST OUTPUT” or turn OFF ‘GPS Status
(GSA, GSV)’, ‘Waypoint/Route (WPL, RTE)’, and ‘GARMIN Proprietary’.
