89000004-200
KA 310 STC Installation Manual
Rev 0
Page 3-1
© Honeywell International Inc. Do not copy without express permission of Honeywell.
3
INSTALLATION OVERVIEW
3.1
Introduction
This chapter is an overview of the steps required for the installation of the KA 310.
3.2
Available Equipment
Table 3-1: KA 310 Part Numbers
Description
P/N
KA 310 Autopilot Adapter
89000004-110-00[ ]
KA 310 Installation Kit
89000004-104
KA 310 Application Software*
89600004-111.01.[ ]
KA 310 Boot Software*
89600004-112.01.[ ]
*Note – KA 310 shipped with software preloaded.
3.3
Installation Materials
3.3.1
Accessories Available from BendixKing
Table 3-2: KA 310 Installation Kit 89000004-104
Note – The table only lists components from the kit that are associated with the KA 310 installation.
3.3.2
Materials Required but Not Supplied
The KA 310 is intended for use with standard aviation accessories. The following items are required for
installation but not supplied:
Table 3-3: Materials Required but Not Supplied
Description
P/N or Specification
Quantity
Note
Wire 22 AWG
M22759/16
As Required
Twisted Shielded Pair Wire 22 AWG
M27500-22
As Required
Twisted Shielded Triple Wire 22 AWG
M27500-22
As Required
#4 Ring Terminals
MS25036-XX
As Required
Push/Pull (manually resettable) Circuit
Breaker (2 amp)
MS3320-XX
1
Label KA 310 Circuit Breaker “AP
ADPT”
Splice
M81824/1-X
As Required
Solder Sleeves
M83519-1-X
As Required
Tie Wraps or Lacing Cord
Commercially Available
As Required
Description
P/N
Qty
Note
DB-9 Connector Installation Kit
89400004-102
1
KA 310 Installation Connector Kit
89400004-114
1
REF:
RELEASED FOR THE EXCLUSIVE USE BY: HONEYWELL EMPLOYEE AMERICAS
UP793797
