Benassi F 1900, Use And Maintenance Manual

Page: 8 / 14

F1900
36
PARTS OF THE MACHINE
1
Wheel engage lever
2
Accelerator hand lever
3
Handles
4
Fuel inlet
5
Motor ignition
6 Grass divider
7
Central cutting blade
8 Oil inlet
9
Wheel release lever
10 Blade engage-release lever
INSTRUCTIONS FOR MOTORHOE ASSEMBLY
•
Remove the power mower from its packing.
•
Fix the handles to the handlebar support using the two screws and two knobs pre-mounted on the handle.
Make sure to position the control cables correctly.
•
Fix the bar to the machine, by unspitting the spring (Pict. 8 Ref. “A”) on the pin (Ref. “B”). Thread the pin in
the casing (Ref. “C”) and thread the spring again (Ref. “A”). Take the little plastic cylinder (Pict. 8 Ref. “D”),
threat it in the grass divider head (Ref. “E”) and threat all in the pin of the lever arm (Ref. “F”), in the holes
on the head and on the cylinder. Fix the head (Ref. “E”) to the bar by screwing two screws (Ref. “G”) in the
threaded holes on the bar.
•
If the machine is to be transported, empty out the petrol tank and always apply the plastic protective strip to
the cutting bar blade. If E.S.M. type, please read the sheet enclosed.
IMPORTANT: THE PACKED MACHINE IS SUPPLIED WITH THE MOTOR WITHOUT OIL OR PETROL.
IMPORTANT:
1)
FIT THE PAWL INTO THE HEAD AND MOUNT IT ONTO THE BAR
(Pict. 9).
2)
FIT THE HEAD AND BAR INTO THE MACHINE PIN. MAKE SURE THE MACHINE PIN GOES INTO THE HOLE
ON THE PAWL
(Pict. 10).
ATTENTION: WRONG OR IMPROPER MOUNTING CAN CAUSE SERIOUS DAMAGE TO THE MACHINE. IN
SUCH CASE, ALL THE WARRANTY CONDITIONS WILL BE NULL.