F1900
39
USE AND ADJUSTMENT
Before beginning to mow grease the moving bar with oil. Then start up the engine following the
directions.
•
Engaging the transmission to the wheels and the cutting bar by means of the clutch lever must be carried
out with the motor at a middle r.p.m. and by slowly releasing the lever.
•
When starting to mow, position the accelerator lever at ¾ or at "MAX" to ensure adequate power.
•
When mowing along a wall or the edge of a sidewalk, be careful to keep a safety distance so that the blade
does not suffer impact. If not, the cutting bar may undergo damage.
•
If the belts are slipping, operate on the adjustment devices (Pict. 5 Ref. "E") which are on the clutch levers.
Leave a gap of about 5 mm before the clutch engage. To adjust the wheel releasing cable, operate on the
adjustment device (Pict. 5 Ref. "F")
•
It is possible to adjust the handle vertically, by acting on the knobs that fix it to the handlebar support: two
different positions are available (Pict. 7 Ref A).
•
It's possible to have another little vertical adjustment of the handle, by rotating the handlebar support, after
having loosened the screws that fix it to the transmission box. Then screw tight again. (Pict. 4 Ref. "B")
•
To regulate the motor, read the manual on the motor under "REGULATIONS".
CAUTION
It is advised not to keep the motor running when the machine is not being used for its
specific
purpose
Summary of Contents for F 1900
Page 2: ...F1900 2...
