17-B
97MU001-F
ANTHEA OPERATION AND INSTALLATION MANUAL
This document is Avantix property and cannot be copied or transmitted without the company's authorization
3. INSTALLING THE ELECTRONIC UNIT
The ANTHEA can be flush mounted on to the bulkhead at any angle attached with 4 screws.
The ANTHEA can be supplied with a bracket upon which it can be mounted with variable
inclination. The bracket is attached with four screws.
The cover of the ANTHEA is hinged. Leave enough space on the left side for opening.
After terminal connecting, pull out as many wires as possible before tightening stuffing
boxes in order to limit HF radiations inside unit.
If wires are hardened, they should not be hardened beyond stuffing boxes input and should
be grounded to casing via stuffing boxes.
The equipment is designed for a battery power supply of 24 volts -10% +30%. Its average
consumption is 200 mA.
The ANTHEA is protected against polarity reversal of the power supply ; if it does not work,
reverse the wires.
The sensor cable is 16 meters long. For greater lengths (up to 50 m), use two junction boxes
and two separate shielded cables (see drawing on next page).
For a 24 V power supply, the value of the fuse is 1A.
For a 220 V power supply, the value of the fuse is 125mA.
