16
Connecng the Appliance to the Gas Supply
In all installa"on condi"ons the gas connec"on should be provided using 8mm (O/D) copper tubing.
No soldered joints
should
be used with the firebox of the appliance. The blind grommet which is supplied in the standard fiKng pack should be used to
close up the knock out hole—simply cut a small cross with a sharp knife in the centre of the grommet—this will then seal
around the gas pipe to provide a "ght seal.
Under no circumstances
should this gas entry hole be
le> open
and
unsealed
as
this can result in
flame reversal
and can cause
damage
to the appliance.
Should this occur the warranty to this appliance will
be rendered void.
Before connec"ng the gas supply to the appliance a gas soundness test should be performed to ensure that the exis"ng pipe
work in the property is sound.
Ensure that the gas line has been purged to prevent dust or debris from entering the appliance.
The burner tray can now be reinstalled into the firebox using the eight screws — see page 21
The gas connec"on should be made to the appliance using the 8mm restrictor isola"on valve supplied with the appliance.
This restrictor elbow is supplied loose and should be fi?ed as per the label on the instruc"on packet.
Prepare the Appliance for Installaon
Remove the front trim panel, the glass panel assembly and the ceramic components from the unit (see glass removal
instruc"ons on page 17).
Remove the burner tray from the appliance. (For instruc"ons see page 21). Remove the knockout for the gas entry, fit rubber
plug aIer sliKng for gas pipe entry—see below for full details.
Fit the slide lever to the burner tray using the 2 (two) screws provided.
Carefully slide the firebox into the opening. (Note the rubber seal is pre-fi?ed to the appliance on the sealing face).
THIS APPLIANCE CAN BE INSTALLED AS A HOLE IN THE WALL INSTALLATION. FULL DETAILS OF THIS TYPE OF INSTALLATION ARE
SUPPLIED WITH THE HIW INSTALLATION KIT.
THE INSTALLER MUST INFORM THE USER OF THE FOLLOWING IMPORTANT NOTICES AFTER A HOLE IN THE WALL INSTALLATION HAS
BEEN UNDERTAKEN.
1.
The user must be made aware to fit a secure fireguard where the room is used by elderly, infirm, infants or young children.
2.
The customer should be advised to fit a hearth panel or a physical barrier in accordance with BS5871-2. Should this advice not
be followed the customer should be advised to give due to considera"on to the safety of the occupants in the room where the
appliance is to be installed.
3.
The user must be made aware to keep the area immediately in front of the appliance clear of combus"bles items. This does
not include the floor covering however such covering should be fixed.
4.
The user must ensure that other occupants of the room where the appliance is installed are no"fied to not get unnecessarily
close to the appliance when in use or to posi"on any furniture or appliances too close to the fire.
Fix the appliance into posi"on using the eight (8) securing
nuts supplied. Note the appliance has slots at these
posi"ons to allow a small amount of movement leI or
right to allow it to be secured centrally. See adjacent
diagram.
These nuts need to be fixed using the special magne"sed
socket driver (supplied).
UNDER NO CIRCUMSTANCES SHOULD THIS
SOCKET TOOL BE REMOVED FROM THE SITE,
IT WILL BE NEEDED FOR FUTURE SERVICING
OF THIS APPLIANCE.
INSTALLING THE APPLIANCE
INSTALLING THE APPLIANCE AS HIW
(Hole In the Wall)
