7
5.
INSTALLATION INSTRUCTIONS
Fire Installation
Before You Start
•
The appliance Data Plate is located Underneath the Heater box
–
Disconnect
from the mains supply before removing the Glass as described in the
maintenance section.
•
Required for installation: 4 off screws and plugs suitable for the wall media
(Not supplied)
•
This fire should not be installed into an open / existing fireplace without the
opening being professionally blanked off to reduce the risk of a back draught,
which could cause the safety cut-out to operate.
•
Check that the supply voltage details on your flame effect fire are in
accordance with your electrical supply. Your fire is fitted with a plug
incorporating a 13 Amp fuse. In the event of replacing the fuse in the plug
supplied, a 13 Amp fuse approved by ASTA to BS 1362 must be used. Before
switching on, please read the following fire installation instructions.
•
In the event of any problems please contact:
Be-Modern Helpline on 0191 430-0901
.
•
Fixings supplied (4 off 20 x 10 trim magnets)
Model 2100
Summary of Contents for 2100
Page 10: ...8 Model 2606 ...
