12
Flame Effect
6b.4 Press to enter the flame effect adjustment
screen.
6b.5 Pre
ss the ‘←’ and ‘→’ button to select the 3
kinds of flame effect.
6b.6
Press the ‘+’ and ‘
-
’ button to select the 5
brightness settings of the flame
effect or the OFF setting.
Normal Mode
6b.7 Normal control mode is factory set. If it is not,
then press
button until the logo
shows up at the upper right corner of the
screen.
6b.8
Press the ‘+’ and ‘
-
’ button to adjust the temperature from 17
℃
to 25
℃
adjustment is in 2
℃
intervals.
6b.9 Press
button to turn on / off heat,
ON
、
OFF will show at the
lower of the screen.
NOTE: It is normal for the fan heater to stop running for periods of time. This
happens because the room temperature is at or above the temperature set on
the remote control. The heater indicator will be turned off after 10s if you have
the flame ON. The heater indicator will stay ON if you use the heating function
only.
Count Down Timer
NOTE: This setting is only for normal mode. It
allows the appliance to go into standby after a set
period of time.
6b.10 Press
to cycle through the settings from
Off and 0.5 hours to 9 hours. The timer logo
and time will show on the screen.
The heater must be in the ON position.
Summary of Contents for 2100
Page 10: ...8 Model 2606 ...
