16
Set up the communication between the remote and appliance
6b.31 The below operations should be carried out before programming, when
changing to a new remote or in the event the appliance cannot be
controlled by the remote:
Hold the reset button on the appliance for 3 seconds (pen Point may
needed) until you hear 3 short beeps from the unit, release the button.
Press the
button on the remote, the programming is finished when
you hear 1
long beep from the appliance.
6b.32 Resetting the code for remote control is necessary if the appliance
operates wrongly or the remote control does not operate correctly.
Open the back cover of the remote control.
Press the Reset button on remote handset.
Follow the steps 6b.31
Resetting the Thermal Cut Out
6b.33 This appliance is fitted with an Electronic Safety Control (E.S.). This is a
safety device, which switches off the fire if, for any reason, the appliance
overheats, e.g. if covered. If the heater stops operating while the flame
effect continues working normally, this indicates that the E.S. Control is in
operation. The E.S. Control can only be reset after the appliance has
cooled down, and the appliance has been reset. Resetting of the E.S.
Control proceeds is as follows:
6b.34 Switch off the appliance (Manual On / Off switch) and leave it off for
approximately 10-15 minutes.
6b.35 Remove any obstruction to the fan heater outlet or fan blades etc. Make
sure that the power supply is disconnected with the plug socket outlet
while doing this.
6b.36 Switch on the appliance and the E.S. Control will be re-set.
6b.37 Ensure that the appliance is functioning correctly. If the E.S. Control
operates again, the appliance should be checked by a competent
electrician.
Summary of Contents for 2100
Page 10: ...8 Model 2606 ...
