200697_5
Page 3
Please unpack carefully ensuring that any loose parts and all packing items are removed. Read any warning labels carefully (see Maintenance Section).
Place waste packaging back into box and dispose of RESPONSIBLY.
The appliance must be positioned so that plug or fused spur is accessible. Only when you are certain that you have completed the
installation should you plug in and switch on at the wall socket.
Before You Start
•
The appliance Data Plate is located on the top of the Heater box
– Disconnect from the mains supply before removing the Glass as described
in the maintenance section.
•
This fire should not be positioned into an open / existing fireplace without the opening being professionally blanked off to reduce the risk of a
back draught, which could cause the safety cut-out to operate.
•
The fire has two spring steel brackets affixed to either side. These are used to hold the fire in the correct position when inserted into the
recess / surround as below.
Fire Positioning:
Figure 1
– Recess / Surround Dimensions (All Dims are in mm)
•
Ensure that the aperture dimensions are as to the above specification, please note that this fire should not be positioned into an open /
existing fireplace without the opening being professionally blanked off to reduce the risk of a back draught, which could cause the safety cut-
out to operate.
•
The appliance must be positioned so that plug or fused spur is accessible. Only when you are certain that you have completed the installation
should you plug in and switch on at the wall socket.
•
Offer the unit into position central to the opening, gently push the fire backwards into the recess / surround until it is flush against the wall /
panel.
•
The spring clips will keep the fire in position
Fitting the Trim:
•
Three sided trim
: Use the 4 magnets provided, these should be positioned on the most forward face next to the glass screen.
•
Four sided trim
: 2 x 10mm and 1 x 7mm magnets should be positioned on the inner rear face of each trim leg 100mm from the base. Offer
up the trim to the fire, hooking the trim in place on the fire body's top edge and allow the magnets to pull the base in to position. Care most be
taken when position trims not to damage the mounting face.
