Belshaw Bros., Inc.
•
www.belshaw.com
•
Phone 206-322-5474
•
Fax 206-322-5425
Donut Cutter Type F TS
MN-1532EN
3
comply with CE standards, unless you have
this work done by a qualified technician.
4. Thread a 1/4-20 bolt through each of the
holes in the fryer’s feet and into the floor.
WARNING
When the machine is column-mounted on a
fryer, make sure the fryer is securely
fastened to the floor. If the fryer is not
fastened to the floor, the weight of the
cutter could cause the fryer to tip over,
resulting in serious burns, other injury, or
death.
Installing the Column
To install the column, follow the instructions
appropriate for your fryer. The four sets of
instructions below explain how to install the
column on the following fryers:
•
Pre-1990 Belshaw Open-Kettle Electric
Fryers;
•
Other Belshaw Open-Kettle Fryers (this
includes all Belshaw Open-Kettle Gas
Fryers, and Belshaw Electric Fryers
manufactured since 1990);
•
Belshaw Century fryers; and
•
Non-Belshaw Fryers
Pre-1990 Belshaw Open-Kettle Electric
Fryers
To install the column on a Belshaw electric fryer
made before 1990, follow these steps:
1. Slide the column mounting brackets onto the
column.
2.
Remove the six nuts and washers from the
mounting blocks on the back of the fryer
cabinet.
3.
(On older Belshaw fryers with narrow kettle
flanges, there are no mounting blocks. The
mounting holes are pre-punched in the sheet
metal cabinet.)
4. Slide the mounting brackets onto the bolts.
5. Replace the washers and nuts you removed
in step 3, and tighten the nuts.
6. With the column resting on the floor, secure
the column by tightening the two 5/16-18 x
1” square head set screws (provided) in the
mounting brackets.
Other Belshaw Open-Kettle Fryers
Read this section if you want to column-mount
the Type F Donut Cutter on a Belshaw open-
kettle gas fryer or on a Belshaw open-kettle
electric fryer manufactured since 1990. To
install the column, follow these steps:
1. Slide the column mounting brackets onto the
column.
2. There is a mounting plate on the side of the
fryer cabinet; the plate has two sets of three
holes in it. Align the holes in the mounting
brackets with these holes. Fasten the
mounting brackets to the plate using the six
lock washers and 5/16-18 x 1” hex-head
screws provided.
3. With the column resting on the floor, secure
the column by tightening the two 5/16-18 x
1” square head set screws (provided) in the
mounting brackets.
Belshaw Century Fryers
To install the column on a Belshaw Century
Fryer, follow these steps:
1.
Have a qualified technician use an
appropriate tool to create holes in the fryer’s
frame assembly for installing the column
mounting brackets.
2.
We cannot guarantee that the Type F Donut
Cutter or the Century Fryer will comply with
CE standards unless you have this work
done by a qualified technician.
3. Slide the column mounting brackets onto the
column.
