Belshaw Brothers 22587-20, Operator'S Manual

Page: 29 / 71

Belshaw Bros., Inc.
•
www.belshaw.com
•
Phone 206-322-5474
•
Fax 206-322-5425
2 MN-1853EN Insider TS
WARNING
The Insider is “intended for use in
noncombustible surroundings only.”
WARNING
Electrical shock hazard. Have power off
and disconnected at source before
making connections.
Insider Assembly
WARNING
DO NOT connect the insider to power
until all assembly has been completed
and the fire suppression system has
been set up and checked by certified
personnel.
Note: Some of the following items may be
shipped installed. See illustrations A & B for
Insider assembly.
1. Unpack and setup the Mark II, V, or IX
Fryer per instructions in the operator’s
manual.
2. Install the Insider cabinet legs to the
threaded holes in the bottom four corners of
the frame. Level the cabinet by screwing the
four legs all the way in and then unscrewing
individual legs as required to level the
counter top.
2a. The optional casters can be used in place of
the legs and are installed in the threaded
holes in the bottom four corners of the
frame. Install a flat washer between the
caster and frame. Use the 7/16” hex nut
beneath the lower wheel raceway to install.
3. Lift the Mark II, V, or IX Fryer assembly on
the cabinet top and place over the locating
pins. This properly locates the fryer under
the fire suppression nozzles.
4. Remove the protective paper and the vinyl
from the sheet metal, windows and doors.
5. Install the lower back door track by
dropping it over the two locking tabs in the
lower door opening.
6. Install the poly-carbonate windows by
inserting them in the upper channel and
sliding them over the two locking pins.
7. The two back sliding doors are installed by
lifting them into the door runners.
8. Install the grease trap under the hood and
install the primary grease filter by turning
sideways and up through the large opening
under the hood. Locate the filter between
the angle guides and against the interlock
switch.
9. Install the cell support assembly into the
hood compartment located by the back door
hinge side. Slide it straight in between the
two baffles and then drop straight down to
the hood bottom. It will not fit if installed at
an angle. The grease tray slides into the cell
support.
10. The air cleaner cell will slide into the hood
on top of the cell support. Slide the cell
straight into the opening so as not to damage
the cell top contact tab.
CAUTION
Installing the air cleaner cell at an angle
may damage the cells electrical contact.
DO NOT force the cell into place.