Bracket Cover
DO NOT mount to metal studs.
Precaution for Installation
(1) The light backboard must be securely mounted to the wall
studs.
(2)
For electrical code compliance, confirm code
requirements in your area.
Mounting to the backboard
1) A maximum of 71” to the top of the backboard from the
floor.
2) A minimum of 8” from the top of the backboard to the
ceiling.
3) It is important to locate the backboard no closer than 50”
to the perpendicular wall.
4) The backboard should be approximately mid-line of the
dental chair.
I
NSTALLATION
1. With a 3/16” drill, drill four (4) pilot holes approxi
mately 2” depth. See page 44.
2. Mount Wall Plate Assembly to the studs, with four (4)
lag bolts and washers (Supplied).
3. Remove Bracket Cover by removing two (2)screws
from it. This cover will be attached later on.
3 Installation
Necessary tools
Phillips screwdriver No. 1,2,3
Hex key wrench; width across flats: 2 mm,3 mm,4 mm
Long nose pliers
45
Summary of Contents for Bel-Nova AL-D101G
Page 1: ...Bel Nova INSTALLATION INSTRUCTIONS...
Page 55: ...NOTE...
