Bellfires VENTO CLASSIC LARGE, Instructions For Use & Manual Daily Maintenance, Page: 77 / 96

53
Bell fi res
English
Installation instructions
The appliance can now be built in.
First determine the places for the ventilation ducts (grills, at the top and bottom of the
chimney breast).
The appliance can be built in using brickwork or by means of fi re-resistant plates that
are screwed to a metal frame. You can, if you like, erect a natural stone mantelpiece in
front of this.
The edge to which the materials for building in the appliance may be used:
Top of hearth: Top edge: transition metal - glass.
Left/right of hearth: Up the to visible edge of the “post” L/R.:
transition metal - “post”.
Note ! : Ensure that there is a clearence of
2 mm between the brickwork/
fi reproof plate and the post to allow
for expansion of the appliance due to
heat. In addition, the “posts” should
be at all time easily removable for
maintenance to the appliance.
Bottom of hearth: Up to level with the top of the “support girder”.
Note ! : Ensure that there is a clearence of
2 mm between the brickwork/
fi reproof plate and the “girder” to
allow for expansion of the appliance
due to heat. In addition, the girder
should be at all time easily
removable for maintenance to the
appliance.
The net opening in the wall that arises is approximately: 874 x 674 mm [W x H]
The appliance is supplied with a straight pressed steel lintel as option to allow installa-
tion against a fl at wall or in a fi replace.
A heat-resistant sealing cord should be placed between the top of the edge and the lo-
wer side of the lintel to allow vertical expansion of the appliance and to prevent cracking
the fi replace.
Do not use masking tape on the appliance
when installing and plastering.
Tape can damage the fi nish of the hearth.