Bellfires VENTO CLASSIC LARGE, Instructions For Use & Manual Daily Maintenance

Page: 15 / 96

15
Bell fi res
English
Instructions for use
Programming the timer: P1 and P2
• Select the desired mode of operation by pressing the SET button briefl y.
• Press the SET button until P1 (heating period 1) and the time appear in the
display. (The time indication fl ashes.)
• Set the time for the beginning of the fi rst heating period by pressing (large fl ame)
for houre and (small fl ame) for minute’setting.
• Press the
SET button briefl y; P1 appears on the display. Set the time for the end
of the fi rst heating period.
• Press
SET again to set the second heating period P2 (heat ON ) and P2 (heat
OFF ).
• Wait a moment or press OFF to switch back to mode.
2.3.3 Operation (Remote Control)
Igniting the fi re
• Open the gas supply valve in the gas pipe to the fi re.
• Press the “
O I ” switch on the gas control block to the “ I ” position.
• Turn the operating knob on the gas control block to the ON position.
• Switch the hand-held transmitter to the position.
• On the hand-held transmitter, press the OFF and (large fl ame) buttons
simultaneously. A short tone will signal the start. Release the buttons. Short beeps
will then follow until the pilot light and main burner are ignited. Once the main burner
has been ignited, the fl ame height will automatically rise to the maximum position.
Important: • If the pilot fl ame goes out for any reason, wait for 5 minutes
before attempting to re-light it.
• If the pilot light does not ignite after 3 ignition attempts;
close the gas tap and warn the fi tter.
• Once the pilot light is burning, the main burner must ignite
within 10 seconds automatically.
If this does not happen, immediately close the gas tap and
warn the fi tter.
• If the main burner ignites with a pop; immediately close the
gas tap and warn the fi tter.