15
OPERATION INSTRUCTIONS
OPERATION INSTRUCTIONS
To check for a leak:
1. Make 2-3 oz. leak check solution (one part
liquid dishwashing detergent and three parts
water).
2. Apply several drops of solution where
regulator connects to cylinder and to all hose
and valve connections
3. Make sure all patio heater and light valves
are OFF.
4. Turn cylinder valve ON.
If bubbles appear at any connection, there is a
leak.
1. Turn cylinder valve OFF.
2.
3.
If NO bubbles appear at any connection, the connections are secure.
NOTE:
Whenever gas connections are loosened or removed, you must perform a complete leak test.
WARNING
leak tested and do not leak.
1
Regulator / Cylinder
connection
If leak is at regulator/cylinder valve connection:
Disconnect, reconnect, and perform another leak
check. Apply the soapy solution to all hose and
valve connections. If you continue to see
bubbles after several attempts,defective cylinder
valve is defective and should be returned to
cylinder’s place of purchase.
If leak is at hose/regulator connection:
This part is defective and you should contact
thecustomer service department for replace-
ment.
OPERATION INSTRUCTIONS
