BC 350 Operators Manual
BC 350 Operators Manual
7
Assembly Instructions
With you machine you will find the following items:
- 4 Legs.
- 4 Wing Nuts to tighten the legs.
- 1 Rubber plug for the water pan.
- 2 Keys (1) axle of the blade, (1) Hexagonal.
Apart from this, you must take off the metal strip sealing the saddle. Then, place the
saddle onto the water pan lodging its grooved wheels into the guides.
WARNING
!
IT IS A LIGHT MACHINE WHICH CAN BE MOVED WITHOUT
ANY EFFORT AND DANGER, WHEN CARRIED OUT BY 2 PEOPLE.
Blade Assembly
-
Disconnect the plug from the electric network.
-
Throw away any worn out, bent or cracked blades.
-
Remove the blade guard, ad loosen the fasteners which attach it to the
headstock.
-
Fix the axle of the disc by introducing the key into the hole of the axle,
and loosen the nut of the blade using the hexagonal key.
-
Remove the outer plate and then change the blade. Centre the blade
before tightening. The blade is set in place by tightening the nut and
fixing the keys.
-
Re-attache the blade guard, and tighten the fasteners.
Fasten the blade ny tightening the nut. Use the set of tools that you receive with the
machine.
GB
10
Troubleshooting Guide
Problem
Cause
Remedy
The motor has no
Low Voltage
Increase the cable section
power.
or in its case, find a solution
to the slow voltage which
might be due to the
electricity main supply.
Bad Connection
Check that the motor is
connected to the same
voltage as the mains
supply.
The machine doesn’t Looseness in wheels
Change the wheels or
cut straight at 90
º
adjust them.
angle.
Incorrect Blade
Change the blade. Use the
appropriate blade to the
material being cut.
The machine isn’t lined up.
Line up according to
instructions
The rulers are not
Loosen the screws and
perpendicular to the blade.
place the rulers at right-
angle to the blade.
The blade has lost
Blunting of the diamond
Cut an abrasive material
its cutting power.
coating.
(Stoneware, concrete,
Emery)
The water pump
The propellar is blocked
Unscrew the lid and remove
doesn’t work.
the items (mud and grit)
blocking the propellar
The pump is burnt.
Change the pump.
The pump is badly
Connect properly (See
connected.
operating instructions)
The mitre is defective The headstock is not
Try to place the headstock
horizontal (this can be due
in a horizontal position
to a short) when you are
using the screw in Fig.4
moving the machine for
mitering.
The power point (in
The coil is burnt.
Change the coil.
its case) doesn’t
remain enclaved.
GB
