INSTALLATION
4
4
.1
Câbles recommandés
Panneau extérieur Unité centrale
Câble UTP CAT5e (AWG24) pour des distances jusqu'à 70 m entre le panneau extérieur et l'unité
centrale et 250 m entre le panneau extérieur et le terminal vidéo. Pour des distances sur le câble
supérieures à 250 m demande des informations supplémentaires auprès du fabricant.
Boîte de jonction audio
Unité centrale
Câble multipaire, flexible (Cu) 2 ou 3 x 0,75 mm ² pour des distances jusqu'à 50 m ou (Cu) 2
ou 3 x 1 mm ² pour des distances allant jusqu'à 100 m.
Serrure électromagnétique (en option)
Unité centrale
Câble multipaire, flexible (Cu) 3x0, 5 mm² ou 3 x 0,75 mm²
Réseau de 230 V
c.a.
4
.
2
Instructions de sécurité relatives à l'installation
ATTENTION! L'installation, la connexion au réseau de 230 V/50 Hz et le
maintien de l'unité centrale ne seront effectués que par du personnel autorisé!
Il est recommandé d'installer l'unité centrale dans un panneau électrique.
ATTENTION! NE PAS RETIRER LE COUVERCLE FRONTAL! RISQUE DE
CHOC ÉLECTRIQUE!
Enlevez seulement les couvercles de protection
ATTENTION! L'alimentation de l'unité centrale du réseau de 230 V/50 Hz
sera faite obligatoirement par deux fusibles automatiques de 10 A (par phase
et neutre). La connexion aux bornes F et N de l'unité centrale serra faite par
deux fils (Cu) isolés avec la section 0,75 mm2.
ATTENTION! Lors de l'installation, le raccordement de l'unité centrale au
réseau de 230 V/50Hz et du service, les fusibles de protection du panneau doit
être déclenchés (POWER OFF).
Il est OBLIGATOIRE de connecter le fil de mise à la terre (Cu) 0,75 mm2
entre la borne de mise à la terre du panneau électrique
et la borne de
mise à la terre de l'unité centrale
.
IMPORTANT ! Avant l'accouplement des fusibles d'alimentation de l'unité
centrale vérifiez l'exactitude des connexions dans les installations. Vérifiez
visuellement et par mesure avec un ohmmètre.
IMPORTANT!
Installez les couvercles de protection des connexions de l'unité
centrale avant de connecter le 2 fusibles d'alimentation (230V/50Hz).
ATTENTION
à la polarité de bornes lors du raccordement à l'unité centrale
d'une batterie tampon rechargeable (max. 7 Ah). L'inversion des bornes conduit
au dommage de la batterie. L'installation et le raccordement de la batterie sera
effectué par le personnel autorisé.
NE TOUCHEZ PAS les fils sortis dans les connecteurs et les bornes de l'unité
centrale. Débranchez les fusibles (10 A) sur la phase et le neutre de l'unité
centrale.
ATTENTION! N'alimentez pas séparément les composants de l'installation
(panneau extérieur, terminaux, etc.) à des tensions supérieures à 15V
c.c.
ou
directement au réseau (230V/50Hz). RISQUE DE CHOC ELECTRIQUE et de
destruction de l'installation de interphone audio.
Terminal audio
35/92